OUR INSTRUCTIONS ARE BASED ON USING A DK20S, DK3110 AND/OR A COUNTER TOP CONVECTION OVEN. TIMES AND TEMPERATURES WILL VARY DEPENDING ON WHICH EQUIPMENT YOU USE.
Substrate | K102P-2, K103P-2, K120P-2, K226P-2, K226P-2A, K505P-2 , K506P-2, K212, K504P-2, K315, K124P-2, K315, K504P-2, K315, K504P-2, K325P-2, K321P-2, K417P-2, |
---|---|
Temperature | 400°F (204°C) |
Time (min:sec) | 3:30 |
Pressure | Light |
Additional | PROSPRAY-II, Nomex Felt, Pressing Pad |
Recommended Paper | DyeTrans Multi-Purpose or TexPrint |
Heat Press Instructions |
Hover transfer under open heat press for 10 seconds to dry excess moisture. 1. Place 1/2" Nomex Felt Pad on Bottom Table.2. Cover the Nomex Felt Pad with a sheet of protective paper. 3. Use ProSpray to attach your transfer to the ornament. 4. Place the ornament with imaging side face up, on top of Nomex Felt Pad and protective paper, on bottom table. 5. Cover with a sheet of protective paper. 6. Cover it all with a piece of 1/8" Green Rubber Pad and press according to time, temperature, and pressure above. |