OUR INSTRUCTIONS ARE BASED ON USING A DK20S, DK3110 AND/OR A COUNTER TOP CONVECTION OVEN. TIMES AND TEMPERATURES WILL VARY DEPENDING ON WHICH EQUIPMENT YOU USE.
Substrate | CE6X8SHC, CE6X8DS, CE6X8GLO, NS6X6GLO, CE6X6DS, TXT6X6SHC, NS6X6DS, NS6X6SHC, CE6X6GLO, CE6X6SHC, CE3X6DS, CE3X6GLO, CE3X6SHC |
---|---|
Temperature | 400°F (204°C) |
Time (min:sec) | 5: |
Pressure | Medium |
Additional | Heat Tape, 1/8" Heat Conductive Green Rubber, 1/2" Nomex Felt |
Recommended Paper | DyeTrans Multi-Purpose or TexPrint |
Heat Press Instructions |
Hover transfer under open heat press for 10 seconds to dry excess moisture. 1. Place Nomex Felt Pad on Bottom Table.2. Cover the Nomex Felt Pad with a sheet of protective paper. 3. Use Heat Tape to attach your transfer to the tile. 4. Place the tile with imaging side face up, with attached transfer face down, on top of Nomex Felt Pad and protective paper, on bottom table. 5. Cover with a sheet of protective paper. 6. Cover it all with a piece of 1/8" Heat Conductive Green Rubber Pad, and press according to time, temperature, and pressure above. Application notes: Do not use grout for IronClad tiles, especially colored grout which will stain the tiles. Mortar, glue or silicone are recommended. |